20 Most Recent Kenmore Whirlpool Washer Timer 3351811 3351811B - Page 9 Questions & Answers

see if broken wire to display

The tub seal could be broken or or ripped or torn and the tub bearing and the tub seals both need to be replaced then for your washing machine and dryer machine combo.

Check out the videos for lots of ideas. https://www.google.com/search?q=Kenmore+High+efficiency+W10420384A+grinding+noise ..

Yes, but you normally have to remove the case. In the case of a stackable unit, sometimes you can get in from the back panel. https://www.google.com/search?q=kenmore+stackable+washer%2Fdryer+417.94702300+replace+water+level+sensor ..

There should be one bolt down inside the agitator that you have to get to. Or like this video it has some weird plastic device that you still have to unscrew: https://youtu.be/lRlCO_yEfsc

It happens to me every time I do that same thing. Be careful when you adjust water levels.

Probably the gearbox as it is the only part you haven't mentioned. Check to see if the belt is broken? They are not easy to work on as the case has to come off. Remove the console, undo the case screws.

repair clinic.com

Try disconnecting from the power for 10 minutes to reset it..

The machine is designed with an automatic water level sensor that even in a deep setting allows at the most 5 inches of water. The reason for this has to do with government regulations regarding energy efficiency. While you could check intake hoses, this does not change the facts. This would seem to possibly limiit the wash load. I would refer to the manual for any insight about that. My suggestion is to place the laundry evenly distributed just below the top holes of the basket.. For me to say it had 3.5 cubic feet capacity is of little value because who measures laundry by cubic feet. I hope the suggestion is of some help. https://www.hunker.com/13410750/troubleshooting-a-kenmore-700-washer https://readytodiy.com/kenmore-washer-wont-fill-keeps-filling-fills-but-not-enough-0051/

Poss. Outlet hose/trap blocked or hose kinked.

Disconnecting from the mains power for 5 minutes is normally the best reset procedure. Some have additional button press combinations. https://www.google.com/search?q=Kenmore+417.61712510 ..

Question edited for clarity. Google says this is the manual. Page 11 has the dimensions. https://c.searspartsdirect.com/pd-content/is/content/Sears/L0305262 ..

Start button could be damaged or faulty.

The F5 error code indicates that the Central Control Unit (main machine control board) detects a temperature sensor resistance that is out of the normal range. The F5 error is normally caused by a failed NTC temperature sensor.

The line fuse has blown for your washing machine and should be replaced.

Check the following:
Are the water inlet hoses kinked or clogged?
Are the water inlet valve screens clear?
Press STOP to clear display.

Your drain pump could be plugged and needs to be unplugged or is not working and should be replaced for your washing machine.

May be a bad door switch. Washers usually let you open the machine (top load) while in wash, but not for rinse and spin because of the high speed. If the door switch is bad, it may think the door is always open and therefore wont go past the wash cycle.

use google for that. all washers made have 2 manuals and spec sheet and sales brochure. google is your friend , do it or ask any kid for help, (school classes)