AT&T E5965C Cordless Phone "searching base id" Questions

...searching for base. When attempting to enter base ID into cordless phones message T23 PD displayed and phone starts beeping. Same problem: registering base ID on cordless get T23 PD error and ...

...Searching for Base". I bought a new battery, reset the phone system (VTech 2431), and place the accessory base near the phone system. The phone no longer was looking for the base. The LED read "VTech ...

...SEARCHING". Followed Motorola's Tech Support instructions to reset and de-register/re-register handsets but without success. De-registered all handsets successfully but re-registration does not work, ...

Searching for Base' on the display,(The bold is for your question specifically but I thought you may like all of the information for getting a phone hooked up) ON the Base unit press MENU, scroll down

...base it will say searching. Make sure the handset is in range of the base and the base is connected to the power.   I pulled the batteries out of each phone. Unplugged the base power for a few ...

...upon recharging, it keeps saying "searching for base". Lookg at the base, I can find no ID to input. How do I make the cordless handset pind its base? I plugged in the base. Hmm, was that

...connect to base unit...stuck at searching...when menu is pressed drain battery rapidly and goes blank! Try placing the handset in the base unit to register it. Then see if it is found by the

...searching for base". Help First thing you must do, is clear the base memory of the phones. To deregister all handsets: Select MENU on the base, scroll to SETUP BASE, then select OK. Scroll to ...

...searching mode. Phone lines are working just not base Your base station is dead, this is common with Uniden phones. You will need to purchase a new base station. You can use the new base station with ...

...searching for base." the other 2 the batteries have just went dead again. i've tried pulling the batteries out and unplugging the base for a few minutes - this does not work. i've tried ...