...clutch lever assembly (where the cable attaches to the gearbox) has gotten out of position on the Axle push lever (the shaft that goes into the side cover and the lever is attached to). The shaft is ...
...lever assembly and the clutch cable make a 90 degree angle. There should be a casting index on the case as well to show exactly where the push lever should be located. Just remember that when the ...
...or you have the clutch misaligned. You can check for proper operation with the bike off, and the clutch cover off while pulling the clutch lever. Should be able to see it move 1/4-3/8 of an
clutch lever please help me Be sure the clutch lever is adjusted for 1/8" to1/4" free play at the outside end of the lever. If the oil is extremely dirty, the grit can cause the clutch to drag. Change
...clutch lever has tention as it should , ive been told to see if the arm pulls the presure plate and it does the problem seemed to come from no where. i was out on it one day, parked it upand left it ...
...clutch lever is pulled in. The push lever axle (I think this is what you are calling the main shaft) sits in a hole on the side cover. The gear on the axle engages the push rod and the push rod ...
...clutch i pull in mt lever and i cant push the bike. it wants to go with the clutch engaged. the cable is pulling the clutch you can see it on the casing and its being pulled has far has it can be try ...
Question about Yamaha YZ 125 Motorcycles
...and put the bike in gear, rev the engine a little and let the clutch lever out SLOWLY and see if the engine stalls when the lever is fuly out. If it doesn't stall then your clutch needs
...am not it stalls The clutch is dragging, you have to adjust the clutch cable so the clutch is not engaging when you pull the lever. Could also be a bad clutch spring but I would adust the cable
694 questions posted
Usually answered in minutes!
147 Questions
12 Questions
8 Questions
7 Questions
1 Questions
