2000 Yamaha YZF-R6 "float level set" Questions

Ad

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...float level setting for the r6 carburetors? Connect a clear tube to the drainplug of each carb and secure them to side above the float chamber. Make sure bike is on level ground and unscrew the drain ...

Ad

...float level on HSC40 Hitachi carburetors on 1986 Virago I put new carburetor kits in my 1986 Virago 1100 motorcycle and am having trouble getting the float level right.I have removed and replaced the ...

Ad

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...Float tabs come set flat to surrounding plate, bend up to decrease level and down to raise level. Raised level too much and you risk fuel overflow on sustained inclines and too low a level and you ...

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...do i set the floats on a 1985 Yamaha xj 700N Maxim? with the float bowl off and holding the carb level, adjust the float where it is level and the jet is up enough to seal. float should be set

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...float level several times and still have same problem. We replaced the vapor valve in the vent line from the tank and still have same problem...Any ideas? Have I missed any thing? Replace the needle ...

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...float level and air setting the air screw gets turn in fully and the turned out 2 turns this will set it right for most bikes you might have to play with it either half a turn either way When setting ...

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...float level. The picture below will allow you to become familiar with the parts that are responsible for maintaining the correct float level in your carb. There are four basic parts, the floats ...

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...Float level gauge and active data list (taken from the workshop manual) is required to carry out the adjustment. But you can simply adjust the float level correctly without any gauge. - Hold the ...

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...GPZ600 carby flooding engine when stopped, float needles look ok, all float levels equal. sounds like the float level is set to high and it is laeking out the over flow. try adjusting float

Question about Yamaha YZF-R6 Motorcycles

1 Answer

...float level. Sounds like you did not get the float adjustment set correctly. It is very particular and it is critical for proper running etc etc. Carb has to be set on the throat and then tilted ...

Not finding what you are looking for?
2000 Yamaha YZF-R6 Logo

303 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...