Question about Yamaha XJ 700 X Maxim Motorcycles
...Two down - two to go. There are only two remaining and identical fuel hoses - they are actually float bowl vent/overflow hoses. There are 2 more T fittings on the X Mikunis - both are at the same ...
...Mikuni carb. Parts are pretty good to find for them. They often have a drain screw on the bottom of the float bowl. You can check here to see if fuel is filling the carbies by backing this off a ...
...mikuni carb float Pull the float bowl and float bowl gasket off the carburetor. Place the carburetor upside down and let the float rest against the float needle. Measure the distance between the ...
Question about Mikuni Motorcycles
Float level setting on Mikuni carb, 30-32 DIDTF Mitzi L200. Remove the float bowl on the carb. Hold the carb upside down, the set the floats level.
Question about Motorcycles
Need the float height setting for my VM 24 round bore Mikuni carb All the Mikuni VM's under 26mm are the same 15-17mm from the gasket surface with the tab just barely touching the float needle pin.
UK gs550E Mikuni carb float heights. Pre CV type. sadly we do not know the float height specs for any thing not in the usa
Question about Mikuni Motorcycles
...float arm must be separately.. you will have to get a manual or http://www.mikuni.com/ and find the info you need.. if they are too low you will lean out.. if they are too high you will get gas ...
...mikuni carb. it gets fuel to the carb but it floods and will not get gas to the cylinder at all A couple of possibilities- - Float is corroded and not floating - Valve either gummed up or worn and ...
335 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
292 Questions
290 Questions