...a sprcial oil, noy motor oil. If oil is correct, Is the cable and release levers fully disengaging the clutch? There is an adjustment for the rod inside the clutcjh hub . That could be short
...adjustment is correct, tighten the clutch in-line cable locknut and slide the rubber boot over the cable adjuster. 10. Install the clutch inspection cover quad ring onto the primary chain case ...
Question about Yamaha XJ 700 X Maxim Motorcycles
...adjustment is correct, tighten the clutch in-line cable locknut and slide the rubber boot over the cable adjuster. 10. Install the clutch inspection cover quad ring onto the primary chain case ...
...clutch rod adjustment Slide the rubber boot away from the clutch cable adjuster. Loosen the cable locknut and turn the adjuster to provide as much cable slack at the clutch lever as possible. Support ...
Question about Yamaha XJ 700 X Maxim Motorcycles
...adjustment at the clutch lever Remove: - Left Side Cover - Clutch Adjusting Cover Loosen the locknut Turn the adjusting screw in until it is lightly seated - Be careful, the screw will keep turning ...
Question about Yamaha XJ 700 X Maxim Motorcycles
clutch lever and make the adjustment there as needed to get the clutch wear you want it, if the clutch is slipping you may need to have the clutch replace. try to adjust but if the adujster is all the
Question about Yamaha XJ 700 X Maxim Motorcycles
...clutch adjustment is made at the handlebar. Turn the adjustment screw on the handlebar out until the clutch lever has about 1/8 inch of movement (before any tension is felt on the clutch ...
Question about Motorcycles
How do i adjust the clutch on my 2004 Harley Davidson Heritage Softail Manual says back out clutch adjusting screw 1/2 to 1 full turn. When I do this and then set the handle adjuster as per specs the ...
clutch being out of adjustment. Start by loosening the clutch cable at the midway adjuster. remove the derby cover, (over clutch), which will expose the clutch adjusting screw and nut. Loosen the nut,
clutch cable adjustment is about 1/2 way down cable. Remove derby cover on primary cover. Looks similar to this: http://www.hdforums.com/forum/attachments/touring-models/118583d1274757072-derby-covers
335 questions posted
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
292 Questions
290 Questions