1974 Yamaha DT 360 "set points 250" Questions

Ad

Question about Yamaha DT 360 Motorcycles

4 Answers

...set too high at first...compression/****-good spark at the right time-proper fuel/air ratio and it will run are the points at the required gap,check wire from points to coil.the plug lead can break ...

Ad

Question about Yamaha DT 360 Motorcycles

1 Answer

...250 same as an dt 360 the bike has sat in a barn about 4 yrs it will not start removed and cleaned the gas tank went thur the carb new plug used ignition coil compression about 50 to 75 psi i have ...

Ad

Question about Yamaha DT 360 Motorcycles

1 Answer

...set the timing on my drz 250 2002 Since you have taken apart the engine I am going to assume you have some basic mechanical knowledge. If I recall correctly, the camshaft sprockets have #'s 1,2,and 3 ...

Question about Yamaha DT 360 Motorcycles

1 Answer

...points are open. With a feeler gage, set the gap to .35 which is not out of any book I have, but it is a good place to start. You will loosen the screw on the back plate and move it until you get the ...

Question about Yamaha DT 360 Motorcycles

2 Answers

...set. Install the points carefully so the new set does not ground. I assume you already tried new spark plugs and spark plug caps. i would start with new plugs as they are the cheapest part that could ...

Question about Yamaha DT 360 Motorcycles

1 Answer

...points open and close, very clean bike only has 1500 miles on it. you need to set it up on your fire mark not tdc and a simply rule of thumb take a card and use that to set the gap. some times you'll ...

Question about Yamaha DT 360 Motorcycles

1 Answer

...set the points and off she wentonly prob now is the person before me must have had barrel off and not put nuts on proper..i was driving it and top end came loose..looks like will have to get ...

...set the points for a cb360 motorcycle? What tool would you use to set the points gap to 15 thousandths for a cb360 motorcycle? you need a feeler gauge that has a 15 thou. Use a flat .015 thickness ...

Question about Yamaha DT 360 Motorcycles

1 Answer

I have 1971 honda cb450 what do I set the points gap at try .035 ... or you can look at a generic service manual at http://hrca.honda.com/ I love that model!

Question about Yamaha DT 360 Motorcycles

3 Answers

...points break. Set the gap on the points @ 0.016" then adjust the backing plate up or down to get the points to open when the piston hits 1.0 mm before TDC. I hope this what you were looking for Quite ...

Not finding what you are looking for?
1974 Yamaha DT 360 Logo

110 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...