2004 Suzuki VS 1400 Intruder "suzuky causes bike" Questions

...few minutes, but the idle did not go down. So I waited till the next morning, and bike started up fine and idle was back to normal. Any ideas what caused this or causes, and fixes??? check intake ...

2001 SUZUKI INTRUDER 1400. THIS WEEKEND WENT ON A LONG TRIP AND MY BIKE STARTED ACTING UP. IT WOULD NOT DOWN SHIFT FROM 3RD TO 2ND AND I COULDNT GET INTO NEUTRAL UNTIL I PULLED OVER AND TURNED BIKE ...

Have a 1995 Suzuki vs1400 Intruder that is missing or cutting out -- any ideas on the cause of the problem? Idle is fine misses between 2200 & 3000 rpm high rpms are fine. Your Carbs need to be ...

Suzuki Intruder flasher relay I think my flasher relay (control unit) is bad, its making a clicking noise. would thins cause my bike not to start? flasher relay should not stop it from starting. check

Oil leaks from where the shift lever goes into the trans. cover. The bike fell on its side during transport. You have probably damaged the rubber sealing bush or have caused damage to the shifting ...

My suzuki intruder is missing backfiring on the My suzuki intruder 2004, 1400 is missing backfiring on the front cylinder. I have cleaned carbs, put new gas, new spark plugs and still pops and ...

1995 Suzuki Intruder 1400 clutch feels spongy I had the same issue. I used dot 4 break fluid, tilted the bike on end so the clutch reservoir near the handle was level. Poured in the fluid till it was ...

I have a 1980 Goldwing GL 1100 with a stiff clutch leaver. The cable is new and free when disconnected.Still works and changes gears well but really hard on the hand. Change the gearbox oil. Put in ...

my bike crank up fine, and idles fine, but when i hold in the clutch, and press my gear shifter to come out of nuetral my bike jerks and shut off, then it be hard to go back in nuetral until i rock ...

1991 suzuki intruder 1400 starter cranks strong but won't start Hello - the bike is new to me last year. Ran great last summer and this Spring - but noticed that it started to have some problems ...