Question about Suzuki VL 1500 Intruder LC Motorcycles
I have had the shop rebuild the carbs, I have changed the plugs. The rear plug will foul after a long ride 100 miles. cylinder pressure is good. any idea's were to go next? when the shop rebuilt the ...
Question about Suzuki VL 1500 Intruder LC Motorcycles
I have a 2000 suzuki intruder vl 1500 and I jus recently had my whole carb cleaned and all parts replaced. But I have a leak coming from the inside of my engine. Im not sure what it might be. I have ...
Doesn't seem to be getting gas Just bought bike has spark and if I add fuel directly to carburetor it will run until that gas is gone checked fuel filter what else should I check . I am knew to this ...
Question about Suzuki VL 1500 Intruder LC Motorcycles
suzuki intruder 1500 LC I have problem with carburator need to rebuild is a kit available? motorcycle.runs terrible backfires sputters poor gas mileage 135km to atank of gas Intruder carbs are ...
Question about Suzuki VL 1500 Intruder LC Motorcycles
I purchased a 1998 suzuki intruder VL LC 1500 a couple months ago. My problem is I was only getting 23 MPG running 93 octain or higher fuel. It also had a set of bastardized cobra straight pipes on it
Question about Suzuki VL 1500 Intruder LC Motorcycles
...cooled down The thing that will make your pipes turn red while running (usually under load) is your carbs being dirty and the bike is running way to lean. getting to much air and not enough fuel. if ...
bike has been siiting for a year. Have new battery and fuel. It will not start Chances are you will need to clean the carbs. Be sure the gas is even getting to the carbs. Go to the website to see a ...
Question about Suzuki VL 1500 Intruder LC Motorcycles
I have gas dripping from the outside of my carb . It is forming on the bottom next to the jugs and drippind down my idle adjustment. it is a 1998 suzuki vl 1500 lc intruder REmove and rebuild the carb
how do I drain the carb the book says to just reach up and unscrew the plug but doesnt show whereit is? The drain screw is located on the front, lower part of the carb. Please rate my answer. Thanks!
carb adjustment poor mileage 2 things. A carburetor can be adjusted if you have any vacuum ports on the engine. With the engine running, use a Vacuum gauge and adjust the air mix to the highest vacuum
229 questions posted
Usually answered in minutes!
131 Questions
71 Questions
40 Questions
22 Questions