Question about Suzuki VS 1400 Intruder Motorcycles
...level in the float bowl. 5. Worn or dirty inlet valve or seat. 6. Damaged or leaking float assembly. 7. Particle c ontamination in inlet fitting cavity. 8. Damaged petcock diaphragm allowing fuel to ...
Question about Suzuki VS 1400 Intruder Motorcycles
...FYI the fuel system on the 1400 is something Henry Ford would find primitive LOL. If the float needles/seats are worn, or the float levels are not set right, this can cause flooding and ...
Question about Suzuki VS 1400 Intruder Motorcycles
...Float level gauge and active data list (taken from the workshop manual) is required to carry out the adjustment. But you can simply adjust the float level correctly without any gauge. - Hold the ...
Question about Suzuki VS 1400 Intruder Motorcycles
...float level is too high or the float valve is being hung open by dirt or fuel varnish. First, turn the petcock to the 'off' position and then drain the gasoline from each float bowl by loosening the ...
Question about Suzuki VS 1400 Intruder Motorcycles
...GPZ600 carby flooding engine when stopped, float needles look ok, all float levels equal. sounds like the float level is set to high and it is laeking out the over flow. try adjusting float
...jetting (you MIGHT seize the motor), if the level is too low, gas will leak out of the over flow and overall jetting will be off, (this is measuring the float level with the carbs off the
Question about Suzuki VS 1400 Intruder Motorcycles
...float level. The picture below will allow you to become familiar with the parts that are responsible for maintaining the correct float level in your carb. There are four basic parts, the floats ...
...float level; I do not have a gauge. the float level is set with the carb on the bench float should be level with carb body above needle and seat you may nave abad float remove and shake to see if it ...
Question about Suzuki VS 1400 Intruder Motorcycles
...float level on HSC40 Hitachi carburetors on 1986 Virago I put new carburetor kits in my 1986 Virago 1100 motorcycle and am having trouble getting the float level right.I have removed and replaced the ...
...Float tabs come set flat to surrounding plate, bend up to decrease level and down to raise level. Raised level too much and you risk fuel overflow on sustained inclines and too low a level and you ...
65 questions posted
Usually answered in minutes!
102 Questions
52 Questions
34 Questions
29 Questions
30 Questions