2005 Harley Davidson VRSCB V-Rod "change front sprocket" Questions

...front sprocket you have to pull the primary off to change.I get 20000-40000 miles out of a chain and if you keep it adjusted you can get 2 chains to one set of sprockets. Dealers try the BS of not ...

...change the front sprocket you should change both sprockets and chain, as the chain stretches and will cause premature wear of the new sprockets. Complete sets can be found on Ebay for little money, ...

...with the rear and decide it's not enough then you change the front you're out the $$ for the rear. I have a 85 CR 250 I use a 13 and 48 I think is the best for trial in the forest and the CA ...

...change the front sprocket on. On the right side of the bike, you'll see the rear brake master cylinder. The master cylinder must come off as well as the plate that the master cylinder sits on. To get ...

...change sprockets. You can add teeth to the front sprocket or take teeth off of the rear sprocket. In the case of your bike , I do not think there is a 17 tooth front available so your best option ...

...change will occur with an increase in the front sprocket number of teeth. The way to mathematically determine that is to consider the present tooth ratio/RPM and relate that to the desired ratio. ...

...front sprocket cover (6mm hex keys), Remove centre bolt holding sprocket, and prise off sprocket, it's located on a keyway, fit new one in reverse order making sure the key is in place, replace cover ...

...change too.. Top end engine rebuild. Sprocket size depends on the type of riding. Standard should be OK for motocross. If you need more top speed install a larger front sprocket and a smaller rear ...

...change the sprockets.If you go to a 16 tooth front sprocket. two teeth on a front sprocket is like droping 4 teeth on the rear. You could drop 2 teeth on the rear sprocket but a 43 tooth is probably ...

If it is speedo sprocket, get a new one and remove front wheel , change sprocket and reassemble. If Speedo sprocket is being stubborn coming out use something relatively soft and tap it out. Good Luck