Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...clutch is fully released???? Did you get the balls back into the ramp assembly correctly and install them with multi purpose grease to hold them in position while assembling. Also check that the rest ...
...clutch adjusting screw counter-clockwise until resistance is felt, then back-off 1/4 turn. Re-install spring and hex plate, you may have to wiggle the hex nut a bit to get everything to line up. ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...clutch cable, find the bellows looking cover over the cable adjuster. Loosen the lock nut and adjust the cable as short as possible. Back at that the adjuster on the primary cover, slowly turn the ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...clutch off. Remove the plate and take the spring and locknut out. Inside you'll see a screwdriver slot. Turn this screw clockwise while gently pulling on the primary cover. If all the screws are out ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...clutch will not spring back after you pull the clutch handle Unhook both ends of your clutch cable if it is binding at all replace it. If the lever on the motor does not go all the way back to riding ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
clutch handle will not spring back. What should I look for? First check and make sure the cable is not binding,Then check the clutch disengagement arm or the engine,you can try and move it to test the
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...clutch spring. Remove the snap ring and then back off on the tool to release the pressure on the clutch spring. Once the pressure has been removed, remove the adjusting screw assembly, the outer ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...back and is this a concern for clutch where if you follow clutch cable down you will find your mid range adjustment use 1/2 in and 9/16 in wrench and back off now go down to your primary cover and ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...back in it all tightens up too much to squeze the clutch lever. Was wondering if the spring bolts should be tightened until they bottom out or should i just tighten them untill i can feel the ...
Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
...plate then will pull off and the plates will slide off and thats it but what you will require is a torque wrench to torque the clutch spring bolts up after any more info needed get back to me ...
109 questions posted
Usually answered in minutes!
63 Questions
38 Questions
22 Questions
20 Questions