2003 Ducati Multistrada 1000 DS "idle" Questions

it idles fast if I turn the idle down it stalls running rich on top end at fast idle sometimes it will drop to a very low idle and shut off adjust the idle mixture screws first and then adjust the ...

carb problems my idl is to high and i think my Air/fuel ratio is off Ok, lower the idle and adjust the carb to best idle and turn down the idle and readjust the carb to best idle. back and forth till ...

wont idle how to adjust carb Make sure your spark plug is not fouled and the gap is correct, also air filter is properly cleaned. If it still wont idle, locate the idle adjustment on the carb. There ...

my vstar 1100 dies when in idle. acceleration is fine. driving, shifting, everything else is fine. when the bike is coming down to idle, it dies Is the idle speed set too low? If so, adjust it, using ...

trying to adjust the idle speed. running at 1500 instead of 1250 rpm The idle speed is controlled by the bikes computer, the ECU. The 1500RPM idle is normal. If you purchase a Race ECM from Erik Buell

Fast Idle I Have a Yamaha 750 special and I need to slow the idle down. It idles at a little over 2000rpm's I need to get it down to approx. 1000rpm's. My problem is that I don't know which screws to ...

1979 Honda CBX will not idle 1979 honda cbx won't idle, right? Starts easy, runs great. After the engine is warm and you rev the engine, idle will slowly drop and engine dies. Adjust idle up and the ...

06 v-star 1100 when twisting throttle and then back to idle position it takes a while to idle back down or stays at high rpm when cold will not idle at all till warmed up a bit then wont idle down or ...

idles @ 2000rpm when 1st gear engaged idle drops idles @ 2000rpm when 1st engaged idle drops to1000rpm.Bike has 94k on the speedo. idle it down carb settings.possibily throttle cabe needs adjusting.

Currently my bike stalls while idling. How do I set the idle adjustment for a 1980 Yamaha exciter 250 and where is the idle adjustment screw? could also need a idle jet, idle screw, could be muck in ...