1979 Harley Davidson XLH 1000 Sportster "bendix bearing" Questions

...Bendix" unit on the starter shaft in the primary. It's basically a one-way bearing designed to lock up when turned one way and to freewheel when turned the other. When the starter turns the "Bendix" ...

...have a smaller cylinder mounted directly on it? If so, this is the magnetic solenoid that engages a Bendix gear drive on the starter shaft into the engine flywheel gear to crank it. The actual switch ...

where is throw out bearing located on a 93 flhs harley Not heard the terminology throw out bearing do you mean thrust bearing for the clutch or the starter bendix ?

Bendix. Basically, it's a one-way bearing or sprag unit. It is inside the starter assembly and to replace it you must disassemble the starter. The symptoms of this going bad is you'll hear the

...with a bearing then they my replace the bearing and that changes that part number but if they are visually the same and the Bendix's are the same and extend the same then you would be safe to use ...

starter turns not engage If your car starter is turning but is not engaged check your bendix bearing and selenoid.

Stater motor makes a grinding loud grinding noise remove starter and check bearings , if ok then the bendix inside the engine mite be damaged !

...or rounded teeth. Next I'd check the bendix on the starter to make sure you did not lose a bushing or bearing. If the engagement bearing is shot you will have definite problems with the

...Bendix or overrunning clutch, or a bad bearing in the outer primary. Or, you could have a bad starer drive gear or ring gear. There's just no way of knowing for certain until you go into the ...

...primary cover inspected clutch basket and bearings, no signs of excessive wear or damage. could my bendix be getting stuck on ring gear? You could be having an issue with 'heat soaking', is your ...