spring holder and needle jet assembly back onto the carburetor cap and insert the assembly into the top of the carburetor. Screw the main jet into the bottom of the needle jet assembly by accessing it
spring go in the carb, on an s.s 0n my 72 iron head sporty They go in the accelerator pump on the bottom of the float bowl. These are the check valves. Turn the float bowl upside down. There should be
Question about Kymco Venox 250 Motorcycles
...spring and it started up. It looked like it was spitting some gas out onto the ground, but stopped after a few minutes. I filled up the tank and took it for a ride, seemed to want to die ...
Question about Kymco Venox 250 Motorcycles
...bottom of the petcock, (gas valve). Any water or trash in the bowl? Drain a cup of gas from the tank. Any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water ...
...bottom side (upside down) that goes into a groove around the accelerator pump chamber. Put the new diaphragm in, set the spring on top of the diaphragm, make sure the small o-rings are properly ...
...spring in the car top incorrectly. Put everything back to the stock settings (air screw). Double check the intake boot for cracks or separation. The problem is probably very simple , but disassembly ...
...bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all ...
Question about Kymco Venox 250 Motorcycles
...spring I've riden another 350 miles and now this has started. Thanks for any help yo can give, Jerry Drain the carburetors. There should be a screw on the lower side of each carb float bowl. Remove ...
Question about Kymco Venox 250 Motorcycles
...screw it in until it stops and STOP.Now unscrew it the number of turns you wrote down earlier. For any reasons you don't know how many turns. Use 2 turns The top of the carburetor holds the diaphram. ...
...bottom of the bowl and see how much trash or whatever is in there. Turn the bowl upside down and remove the two screws left that hold the accelerator pump cover on. Underneath the cover you'll find a ...
42 questions posted
Usually answered in minutes!
16 Questions
5 Questions
1 Questions
3 Questions
2 Questions