1981 Honda GL 1100 Innerstate Gold Wing "valve clearance goldwing" Questions

...I need the valve settings for 1983 GL1100 goldwing The valve tappet clearances for all Honda Goldwings from 1975 through 1983 are .004" on both the intake and exhaust, when the engine is

...goldwing will not idle i have good firing at all cylinders but sitting on the bike the 2 left side exhaust pipes have good heat out exhaust while the 2 right are just warm,are there adjustment screws ...

pitted valve stem tips can also cause a ticking noise. In any event, do not run the engine with less than the specified .004" valve tappet clearance as this can cause valve damage and compression loss

...goldwing would not run when I bought it. It had sat in garage for 3yrs.I figured it was the carbs so I took them off and cleaned them. Now the bike runs but rough. How do I adjust the carbs. sounds ...

valve clearance specs. Get a feeler gauge and set the valves accordingly. remember to have engine at TDC (top dead center) when checking and adjusting valves. If the valves are the problem they should

...valve clearance should be approx .004 and exhaust valves should be appxox .008 also you may consider taking the coils to a shop and have them tested. coils after warming up will begin to fail once ...

...is not running on all 4 cylinders. Honda recommends the valve clearance be checked and adjusted if needed every 32, 000 miles. If you have never had this service performed it might be time to do