Question about Maxtor Computers & Internet
jumper setting for maxtor n256 diamondmax vl 40 5400 rpm There is usually a diagram on the drive showing the jumper configuration. I tried to make the Jumper setting for maxtor n256 diamondmax vl 40 ...
Question about Maxtor Computers & Internet
jumper settings for a maxtor N256 master with slave I'm trying to get the jumper settings for a maxtor N256 (model 96147H6) that I want to use as a master with a samsung SV1204H as a slave. I have the
jumper settings maxtor n256 model 90510D4 jumper settings Check this diagram. it shows all configuration in detail.. good luck!! Look here: ...
...jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on the top ...
maxtor hd jumper settings n256 91366u4 primary MAXTOR: no jumpers --> Master one jumper --> Slave two jumpers --> Cable Select
Question about Maxtor Computers & Internet
...jumper settings for a Maxtor N256 Hard Drive I have never personally seen one but most drives are the same for the type of jumpers installed. See if this helps you: ...
...N256 The first jumper goes up and down on the two pins just beside the IDE cable slot and the other jumper goes across the top two pins next to it ...
...Jumper settings Here's a link to them on the Seagate site... (Seagate acquired Maxtor) http://www.seagate.com/staticfiles/images/support/en/us/mxo_ata_jumpers_rev.jpg All Maxtor hard disks has a ...
...jumper settings for Maxtor N256 hard drive. Hard drives have three jumper settings on them. 1.MASTER---MA 2.SLAVE---SL 3 CABLE SELECT----CS If you have a hard drive on the end (last) on the ribbon ...
master jumper setting on a n256 Here is a chart for settings
805 questions posted
Usually answered in minutes!
421 Questions
140 Questions