...piston contact, wrong valve springs , too strong or coils compressed be fore valve fully open, valve bounce caused by worn camshaft or weak valve springs. All ways replace a bent push rod don't
...push rod is not bent, if it is replace it, do not try to straighten it. Make sure the rocker arm stud did not loosen, if it did back out, re-tighten. If you're ready to put it back together, you will ...
Question about Coleman Electrical Supplies
...bent push rod. Also check your spark plug anytime it backfires. Even if it appears to be good I would replace it since they are cheap and can go bad and not show any signs of a problem. Finding top ...
...push rods are both in place and don't look bent, also check that the valves are in place. If both valves happen to be in the closed position at this point I usually do a leak down test - pressurize ...
Question about Generac Electrical Supplies
...push rod is bent also. any ideas on what is causing this. Engine turns over fine and no noise. Piston travels up and down checking threw spark plug port sounds like the valve is binding in the valve ...
296 questions posted
Usually answered in minutes!
94 Questions
7 Questions
13 Questions
5 Questions
15 Questions