t go in reverse either Hi, did this happen when you went to use it or while mowing? Also will the lever go in but the mower won't move or won't the lever go in either gear at all? Regards Phil
...mower deck. When the clutch works itself out of adjustment it will quit working. Sometimes it will blow the 20 fuse and the tractor will continue to run, but the blade won't engage. When you then ...
Question about Craftsman Garden
...5 hp lawn tractor ) Mower runs for about 5 min, than dies won't restart . When cool start up ( craftsman 42 in deck 19.5 hp lawn tractor ) check for spark when it dies you could have a bad ...
...mower and it runs, but it won't go into gear it goes into gear, but clutch won' engage the gear. Look under the mower to see if the drive belt has come off or broke. It is the belt that runs ...
tractor - New PTO switch installed, deck recently repaired - new belt - mower blades won"t engage Park brake switch is the most likely culprit,any other would cause the tractor to not turn over in the
GT 275 mower won't engage GT 275 mower won't engage service manual is available for 10 dollarshttp://john-deere.backupmanuals.com/John-Deere-GT275-Lawn-and-Garden-Tractor.html
Tractor won't turn over. Replaced Battery, starter and hotwire to starter getting smoking hot while trying to jump the tractor or start the tractor. Is the engine free to rotate? Can you move it ...
...mower blades shut down and won't come back on when I try to go forward again. on most riding lawn tractors you most first disengage the blades before going into reverse moving the tractor stop, ...
...tractor won't start again .I,m thinking wiring not grounded but where or replacement switch somewhere.give best advise. Some mowers have a mowing reverse safety switch. That safety will kill the ...
1,292 questions posted
Usually answered in minutes!
1,998 Questions
710 Questions
725 Questions
285 Questions
244 Questions