Hobart Handler 125 Ez "welders 120 problems" Questions

...120/90amp wire feed welder.When i try to weld,all i get is a small spark.I turn it off,turn it on and it does it again.The wire feed works good,it just sparks,but will not keep welding.Thanks,Jerry I ...

Have Hobart 140 Handler, The motor won't run to feed the wire, even whith out wire. gas will come on when trigger depressed.Where can I find parts to fix? You need to look at the wiring diagram to see

...120 won't heat enough to weld. What are possible problems? If you are using solid wire, you need to use a shielding gas like Carbon Dioxide or Argon.  Otherwise you will not get *********** and ...

northern tool mig welder,120 volt with gas.The wire feed is not working.When i pull the trigger the wheel that feeds the wire to the gun does not spin,even with no tension on it.The fan works and the ...

I have a general 120 amp, mig 151 from harbor freight. I have it connected to a 220 amp plug. The power comes on and the wire feeds out the end. I cannot get any arc on any metal surface. The welding ...

I have a miller trailblazer 301g. It worked fine yesterday and now only the 120/240 volt outlets will work. No weld output and also the idle will not kick down. when I opened the unit the only visable

I purchased a used Hobart Handler 140 and I think it might have a problem. No matter what Amperage setting and wire speed I can't get any penetration. I am using .30 flux core wire, no shielding ...

I am having weak arc issues and will not weld at any of 5 settings. Any idea what my problem may be? does the machine buzz a lot louder then usual if so you could have a diode gone on the welding ...

...120 volt unit, you will be ok with a gage 12. Most 120V commercial extensions out there are 14 gage, if you want to buy one, choose no longer than 25 ft long. With a 12 gage you can go to 50 ft. with ...

...welders try to weld with it with no luck.please help or give me some ideas.thanks.J.D. I have the same welder. Worked well for 15 years until the drive bearing stopped spinning. I cleaned and oiled ...