Question about Welding Tools
...wire feed wont work properly its brand new never been used adjust more tension on the feed roller make sure that you have the correct groove in use for the wire( turn the feed pulley around on the ...
Question about Welding Tools
...don't come out the fan is the only thing that works the model 117-050 i have a dayton wire feed welder the wire don't come out the fan is the only thing that works the model 117-050 Get a new ...
...new 1 cheers? erratic wire feed speed can be from worn inner liner in the lead the inner lining is like a close woven spring and with the welding wire moving through it , it will wear a groove in the ...
Question about Welding Tools
...wire speed. Checked the feed control switch. Ohms increase and decrease as iMovie the dial. Board bad yes no yep, bad board. you can probably get it repaired for about half the cost of a new one. ...
...wire in the cable from the trigger to the control board - or the switch in the handle is crapping out. If it's had a fair amount of use, or has been bent into some seriously oddball or tweaky ...
...new board for not big $$$? First make sure the nozzle tip is free of any debris and the wire will slide easily. Lift the case and go to the wire feed unit. Loosen the pressure nob then lift up to ...
...wire before welding hardly any and when I tried to put the new spool in I could not get it to feed thru. When I was looking for instructions I noticed the cable guide was sulpposed to have a rubber ...
...wire feed works and it welds, but it isn't getting 12 volt power to the feed. it might be the circuit board. i know the feed works because he supplied a different power source and a riostate, but of ...
...to be running ok, check tension of the drive rollers, and easiest of all - keep your wire dry and fit a new liner. Rusty wire or fouled liner are the biggest cause of feed problems. Best of
...new wire. I looked for a pressure switch thinking there has to be gas pressure present for the feed motor to operate. Didn't find one. I don't have a schematic for the welder. I was told this unit is ...
146 questions posted
Usually answered in minutes!
26 Questions
20 Questions
13 Questions