start up instructions for PM05450-07.02 What is the start up procedure? check the oil level fill fuel tank with fresh fuel open the shut off valve on the bottom of the tank put choke on and turn the ...
Kohler 10 runs only while holding start Gen shuts down as soon as you release start switch. Oil pressure, or no AC output from the stator, check stator and rotor for resisitances and shorts.
Question about Onan Electrical Supplies
Why will my generator start but shuts down when start button is released? Changed control board Power to the motor switching off to ignition system check wording is correct.
Question about Onan Electrical Supplies
shuts down right away. Odds are that the ignition switch or wires are giving you the grief. Thee unit will probably be getting spark power through the starter solenoid (look for a wire there) but when
...Shuts down when starter Switch is released. Check all the ground wires and make sure their not broken or loose. If the wires are good next check the neg. Wire to the coil. Too check the swiitch make ...
Question about Kohler Electrical Supplies
...switch is released, engine will die if sending unit is defective, or you are low on oil. 2) Exhaust temperature sensors. Older units were notorious for burning these up. 3) Cooling Water Temperature ...
wont start i have changed gas and spark plug kill switch in proper position for run? fuel valve on if applicable?choke on ? sorry i had to ask. pull plug out ,connect plug wire and see if spark by ...
Have Onan 3.6 KY propane gen that will not keep running. Runs only as long as start switch is pushed. Then stops immediately after release. Fault code is 15 (underfrequency) and suggests removing ...
...switch. You have power to run the motor while in the start position but lose it when released. Internally it makes contact supplying power to the exciter circuit on the alternator, but when you ...
...shuts down. Here are the most common reasons for your condition. CHECK IF ENGINE KEEPS RUNNING The most common complaint is that the engine starts but will not keep running when the START switch is ...
338 questions posted
Usually answered in minutes!