lower, adjust the float inside the tank to raise the water level. For models that have a ball float, turn the screw on top of the fill valve clockwise to raise the water level. For models that contain
...float arm downward so that it will respond to a lower water level. Try turning off the supply valve, flushing it and listen for water leaking past the flush valve after it closes. If it does, replace ...
lower the float so the water is turned off sooner. If your model has a ball on a metal arm, it is as simple as bending the arm down a little bit. Vertical cylinder types have adjustments on them. Then
...float connects to get the ball lower into the tank. If you are referring to the style float that surrounds the fill tube like a doughnut, most likely you have some sort of build up either on the fill ...
Question about Pegasus Technologies Home
float to go off at a lower water level. If it doesnt replace it. The float is attached to a water shut off valve as it rises to a certain point which you set, when it reaches that water level it shuts
...the fill valve. It has a small metal clip toward the bottom that you need to pinch to raise or lower the float. It also has a large plastic screw with a phillips head at the top for fine
...see a metal clip on the rod that connects to the square float lightly compress the clip for more water in tank lower clip for less raise the clip if this does not work you need to service the ...
...lower (and smaller) than it was a year ago when I first bought it. I can hold the handle down until it quits flushing, and it fills to the correct level, but I shouldn't have to do that. It is the ...
...amount of water entering the tank. As the water fills the tank, the float rises, pushing up the float rod, which in turn pushes up the level that controls the valve allowing water to enter the
the tank overflows you'll need to adjust your float, so that it sits lower in the tank
17 questions posted
Usually answered in minutes!
50 Questions
35 Questions
40 Questions