set up and operate maestri rocama 16 manual stapler to assist in picture framing. Hi. Here is a link to the only additional info. offered on this manual stapler. http://www.romeomaestri.it/serie_lng-1
...stapler is slow to reset after shooting a staple because the drive pin is setting the staples too deep. The o rings were just replaced and this hasn't been an issue until now. I tried adjusting the ...
Question about Heavy Duty Tools & Hardware - Others
...the Clipper Undulated Heavy Duty 3/8" Staples. On the back of the stapler, there is a loading rod. Remove the loading rod and place a set of staples in the chamber, then re-install the loading
Question about Staples Tools & Hardware - Others
...stapler fires), and some allow you to set the sensitivity of the trigger. If yours allows you to adjust the sensitivity, try adjusting it. If it's not adjustable, the trigger probably needs to be ...
stapler tends to recoil a bit and the staples don't set all of the way. If that doesn't solve it for you, you could try using 3/8 staples, since the screen material is of negligible thickness.
...stapler. The staples are not sinking far enough into the tounge of the wood. I have tried setting my compressor all the way to 160 PSI and still no luck. Jim Scadden [email protected] The white ...
Question about Senco Tools & Hardware - Others
...stapler: The SKS L11-17 drives 18 gauge, 1/4" staples. The SKS M12-17 drives 18 gauge, 3/8" staples. The SKS N12-17 drives 16 guage, 7/16" staples. None of them use staples over 1 1/2" long and each ...
stapler. I am using 15.5 x 2" staples. The staples are not setting all the way, and are leaving about 1/8" of the crown in the groove of my oak flooring. I have checked a few scrap pieces in
Question about Arrow Tools & Hardware - Others
Got several t-18 wire staplers. Both misfeed. When I press the spring holder in the back of the frame inward, it works for that cycle. Any advice? Wrong staples or spring has taken a set.
Question about Arrow Tools & Hardware - Others
What size staples and what size Arrow stapler do I need to stable coaxial cable I would use 1/2 inch or larger. Set the staple into the wood and then pull gently to see if it holds.
21 questions posted
Usually answered in minutes!
65 Questions
25 Questions
28 Questions