Homelite Mighty Lite Lawn Trimmer  "tight" Questions

...gas trimmer mo.no. 316.711970 Not much info in the question. You may have organic matter wrapped tightly between the spool housing and the shaft. To fix, removed the spool housing to acess the

#160;pull the cord through the hole on the casing wind the spring back on the strimmer  not to tight but tight enough for the cord to return once pulled. Attach the cord onto the spring this

How do I remove the head for repair. The line spool is off but I can't get the head off Cover the threaded end of the driveshaft with a rag and grasp it firmly with a pair of pliars; holding it ...

...other spring is fine. The plastic Drivers are holding the spring in its spot. I've tried the bolt tight and lose. Check binding of the pulley on it post, that washer is not biding the pulley. Too ...

...If it is clogged the primer will not work. On some of the Walbros and Zamas they use an extra tight filter screen that clogs very easily when you have bad fuel lines. These extra tight filter ...

I changed the blade on my Toro Edger attachment but the left handed thread on the nut doesn't get tight. Is it supposed to or is it some special design that doesn't allow it to be overtightened? Does ...

...Pull the loop out with the starter handle and try starter. If the starter handle does not come up tight to housing reclaim the loop with needle nose and give the pulley one or two more winds and

...rebuild kit. Remove the gas lines (after draining gas). Remove the carb and inspect the screws and tightness of the screws in the 2 end covers. Are the screws tight? If not tighten them up and ...

How do u get the end off to replace the string? Hold the big hub tight and unscrew the small hub underside.if its to tight use a grips or something similar

...the head back on and it will trun but whin you put the nut on it acts like the nut is getting to tight and puching the head up to tight whin i took the head off did i lose something that stops the ...