Craftsman Convertible 25cc. Gas Line Trimmer "install new lines" Questions

installing new line A tip on installing your new line. Soak the package or line in water for 24 hours prior to using it. It takes the "****" out of the line making it easier to wind on the spool.

...install new ones. They just slip through the holes in the tank, re-attach the fuel filter on the supply line. Make sure that the line is long enough so that the filter rests on the back/bottom corner ...

...Install new fuel filter..........Install new fuel Lines.......Install new primer bulb........Clean carburetor. So in some respects, you are probably correct....no fuel filter equals bad fuel entering ...

it stopped auto feeding Have you installed new line? If so, you may have crossed over too much of the line with other turns. Take the time to unwind the line and try again. If you haven't installed ...

install new line? You just pull it off. It takes a lot of force. When re-installing the spool, be sure that the line is inserted in the exit hole and the line is wound in the right direction. I have a

...install new string on Echo SRM 2400 Don't know how to install new string on Echo SRM2400 weed eater.Have new double line Cut two separate pieces of string, about 7 ft. each. Stick the end of the line ...

...install the new line in the tank you need to snip the new fuel hose at an angle to help in the ease of re installing it. Once you get it started you can either reach into the tank with needle nose ...

...extra length to be able to pull the main fuel line thru the tank to install the NEW fuel filter you get. Even if you use your old filter (not recommended) you will need extra length to reinstall

...new fuel lines and a spark plug and cleaned the in tank fuel filter, and the air filter. It will not run in its ususal upright position. We added new clean fuel, a new spark plug and new fuel lines, ...

...install a new fuel line on a weed wacker which line connects to the top port of the carburator ? The one with the filter ?? The esiest way to figure it out is to take the line with the filter and put ...