Black & Decker CD9600SBGB 9.6 Volt Drill With Gift Bag [Misc.] "chuck key" Questions

...chuck or key less chuck.Over the years, key less chucks have been widely used for handheld power tool drills, due to their improving grip torque and convenience. Step 2. If you prefer replacement key ...

...chuck key to attach a drill bit or tool to the machine's chuck. The chuck key inserts to any of the small holes in the front part of the chuck and at the same time its teeth interlocks with the teeth ...

...chuck key allows you to put the end of the key in one of the holes and using the teeth you turn the chuck key thereby loosening the chuck and allowing you to change the bit. if you have a keyed chuck ...

...key & tighten the chuck. 3. hold the drill at the edge of the table & wack the allen key counter clockwise & do it again as needed. 4. dewalt keyless chuck will fit but you might add a washer to ...

...chuck key? If so insert chuck key into chuck as you are about to tighten chuck onto a drill. Then, holding the drill firmly by the chuck end and using a wooden mallet; give the chuck key a sharp blow ...

...chuck key, with the chuck facing toward you, into one of the holes on the right side of the chuck. Strike the key in a clockwise direction with a wooden mallet or similar object. This will loosen the ...

...onto the drive shaft (ie. right hand thread). insert the chuck key into the chuck and tap the chuck key with a hammer so it unscrews in an anti-clock direction to loosen the chuck off the drive

...chuck key into the chuck and give it a hard blow  so you knock it in an anti clockwise direction. If it is a keyless chuck  or you don't have a key try holding the short end of a large ...

...inside, remove it. then place the short side of a 3/8" allen key into the chuck and tighten the chuck... then smack the allen key from the side with a hammer the same direction as forward

chuck key (if it is a key-less chuck you may have to use a pipe wrench or something similiar) and give the key (or wrench) a sharp hit to release it. The chucks are screwed onto the drill with a right