Sta Rite STA-RITE CONTROL BOARD KIT - 42001-0096S "126 temp" Questions

...126 degrees on the digital screen. so it wont heat. it has never done that. How do i fix it Use a thermometer to check the actual temp of the water to see if the units temp probe is accurate. Also ...

...126 is not an error code, but it maybe the temp of the water that the heater is reading. If the heater thinks the water is 126 degrees, it will not start at all. If the heater is reading the wrong ...

...Temp on heater reads 126 degrees F I have a SR poolHeater model SR400NA the water temperture reads 126 degrees F at all times therfore the heater won't turn on. I was thinking it might be the ...

...temp gauge is reading 126 degrees....no service lights are on....the blower motor does not start like usual before the heater kick in......actual water temp is around 75 degrees......tried moving the ...

...temp up and down but then it immediately displays 126! What's up with that. And the service light does not go on. This is a bad thermister or heat sensor. It mounts in your water manifold and if it ...

...temp at 125/126 correct? IF this is what the heater is reading, then the problem is the Thermistor,or temp sensor, and is very easy to replace. If you have an Owner's Manual, there are part numbers ...

...pool heater The water temp reads 125-126 and actual temp is 80. Checked all connections and cleaned. Has thermister gone bad? Good SHOT! That's likely to be the problem - that or a poor

...126 on heater and will not fire. Pool temp @ 72 degrees. Heater set for spa @ 101 degrees. SR400NA Sta-Rite Heater This is a problem with your thermister (heat sensor) You will find this on the left ...

it reads 126 what did you do? the heater doesn't kick on and the water temp is only at 82. That is not a code. Look under the cover on the circuit board for red light.

...temp reads 126 and the water temp is only about 68 so the heater never comes on. This is not an error code. 128 r13 is the normal programming or software version for your model. you need to press the ...