Husqvarna "Chain Saw - 16" Bar, 3 Hp "spark cut" Questions

Ad

Question about Garden

1 Answer

...spark at the plug, start by removing the cut out wire from the ignition switch and try again, if still no spark remove the covers and dissconnect the earth cut ot wire from the ignition unit itself, ...

Ad

Question about Husqvarna Garden

1 Answer

chainsaw cuts 10 times thne stops no spark chainsaw cuts 10 times thne stops no spark No spark is either a bad ignition coil *(dies when it gets hot) or, if you still have points and condensor, time ...

Ad

Question about Husqvarna Garden

1 Answer

357xp 359 After 15 to 30 min. of cutting engine gets extremly hot and cuts off. Checked spark plug,air filter, and made sure all cooling system components are cleaned. I was told it may be the ...

Question about Husqvarna Garden

1 Answer

...cut out' some of the spark. This is normal in this senerio. But, now the real problem causing the senerio; Fuel starvation - 'lean fuel' condition Basic things to check: 1) spark plug 2) spark ...

Question about Craftsman Garden

1 Answer

...for a spark, if no spark, remove the starter cover, now remove the cut out wire from the ignition unit terminal, try again for spark, if no spark, the ignition unit is bad and will require

cut it off it will not start again for about 30 minutes hi everything being = with good compression and fuel system and clear muffler sounds like you may have a faulty tank breather or a ignition coil

...firmly earthed against the cylinder and there is no spark pull the earth cut out wire off the ignition unit to rule out the switch and wire, now try again, if still no spark replace the ignition

...cut out and would not start. Left for half an hour and saw started, run for half a tank of fuel then stoped, now cannot start. Seems to be fuel getting to the spark plug, replaced with new spark plug ...

...and condenser when engine gets warm rotovator still cuts out When the engine cuts out pull the spark plug and put the wire back on and ground the plug to the engine block and pull the cord to ...

...cut how do I fix it runs fine when not cutting Remove the muffler, and check the spark arrestor to see if its clogged with Carbon. Clean it by either wire brushing the carbon, or heat the spark ...

Not finding what you are looking for?
Husqvarna "Chain Saw - 16" Bar, 3 Hp Logo

581 questions posted

Ask a Question

Usually answered in minutes!

Top Husqvarna Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Husqvarna Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...