Husqvarna "Chain Saw - 16" Bar, 3 Hp "chainsaw idles accelerate" Questions

...chainsaw. Why does the chain continue to turn at idle? I just installed a new clutch. Adjusting the idle down causes the saw to shut off upon trying to accelerate. Sounds like the clutch is still ...

Chainsaw starts but will only stay running if i push the primer bulb before it stalls out pump the primer till it's full of fuel Before you start it Warm the engine--turn the H needle on the ...

stihl chainsaw problems stihl 028 av,chainsaw bogs down after running just fine for 20 minutes. it continues to idle okay, but will bog down when accelerated Adjust the high speed screw on carb ...

what is carburetor setting on a2.3 chainsaw There is no fixed carburetor setting on these engines, just two screws to adjust low-end and high-end operation. Special tool may be required, there are ...

...chainsaw does not hesitate when you rapidly accelerate the engine. 8. Adjust the idle speed so that the chain saw idles but does not rotate the chain. That is pretty much 2 jet / 2 cycle carb ...

The idle adjustement screw had fallen out and was lodged under the carb. I put it back where it goes, but continue to have issues with idleing. Also, when I get it to a point where the engine will ...

...chainsaw stards for a few seconds and stops First make sur your fuel mix is correct and thoughrlymixed. Shoul be 50:1 mix. Next make sure you try starting with switch in choke position and pull ...

...I try to accelerate the trimmer from idle it stops sounds like typical carburator issues.Pull carb apart and clean jets if it idles than slow jets are good so its more than likely your high idle

...chainsaw if the engine is in good shape..screw in both carb jets adjusting screws till they seat lightly, then back them out 1 1/2 turns, srew in the throttle adj screw a turn and start the ...

...chainsaw. It won't accelerate, it idles but can't adjust carb to get it to run . While I'm adjusting the carb,every now and then it will accelerate for a few seconds and then back to idle. The ...