Dewalt DC925B Heavy Duty Xrp 18V Cordless Hammerdrill/Drill/Driver Bare Tool "speed settings drill" Questions

...speed. also the clutch is stuck on drill mode but when using the drill with a unibit or such, instead of the drill bogging down and just stopping, the clutch kicks in while set to drill mode. drill ...

settings, but has a "thumb wheel" speed selector - say 1-5, the highest speed should be good for most woods, midrange for particle board, and near the lower end for drywall (less spreading of the mess

...I determine when to yse high speed /low how do I determine when to use high speed /low torque setting on my drill versus low speed /high torque? High spped for drilling Low speed for driving

...speed settings. It gets progressively harder to turn as I go to higher settings. Getting to hammer mode requires a pair of channel locks. run the drill slow while changing the speed of the drill ...

drill the speed does not change.I am able to remove the chuck and the gears,but cannot see the problem. those numbers have nothing to do with speed. They are torque setting for the drill, so you don't

...settings and speed do I use? You should be able to drill at a low speed. Maybe 100-200 rpm. I assume the bit is sharp. I have run into an ocassional new bit that is bad. If it suddenly stops drilling ...

...settings, speed settings don't matter. Is there an internal fuse, or contact coating that might be interrupting power?? Does the drill do anything? Check in the cavity where the battery goes and make ...

...speed selector is between two speeds or the output shaft from the motor to the chuck is broken/stripped. If your drill has a clutch setting you may check to make sure it is on the lowest number ...

...Drill still works, but would prefer to have the full speed rotation for drillin. Was using it back and forth for installing a gate latch and it just suddenly refused to be set back to the drill bit ...

...Drill. Same speed in position 1 or 2 ??? Just open brand new DeWalt 12v Cordless Drill. Model DC742KA. Charged battery. There is no difference in speed on setting 1 or 2 (made sure switch was moved ...