Frigidaire FDL50R1 Dehumidifier "rust" Questions

Dehumidifier is leaking rusty colored water onto the floor The inside of those units are made of galvanized steel. They start to rust out after 2-3 years. I know because I have one. If you have the ...

...of additional value to others with this problem. What I found as the cause for the fuse blowing was rust on the inside of both motors on the armature & frame which had prevented the fan from turning ...

the humidifier does not collect water at all I turned the humidifier on and it does not collect water at all. sounds like you may have a rusted evaporator coil and that has caused a freon leak. it is ...

fan noise but compressor not running and no water collecting in tank coils have some rust- does this mean that the freon has drained and the unit is done? Hi, this very well could be the problem. If ...

dont know how to arrainge the settings .the unit runs but doesnt collect water Hi, If your dehumidifier run for shrter time and if cuts off often and the humidity in the room is high, try adjusting ...

...but wont start remove screws and pull unit out and thro gelan find control panel and clean any rust or grime and apply electro gel to connections. wash out rest of parts too. should work ...

Kenmore 54341900 dehumidifyer compressor stays on too long and freezes up. humidity control is rusted up Hi, Here is a tip that I wrote that will help you understand why and what you can do with a ...

...AAA battery. It is corroded, and the metal bracket that was holding it near the coil has completely rusted. 1. Any idea what part this is? 2. Could this be the reason the dehumidifier is not working? ...

fedders dehumidifier freezing Same freezing problem with a 3 year old fedders. Where is the sensor supposed to be located? I opened mine and found the sensor loose, but could not tell where it was ...

...old. the motor is tight, (can't turn) lubricate the motor bearings with light machine oil. retest. rust causes this. the motor "tries" to turn, more power is needed, still can't turn, power exceeds ...