Franklin Industries Franklin Chef Ice Cube Machine FIM400 "adjust water goes maker" Questions

adjust the time. Another idea would be to partially close the water valve that goes to the ice maker unit, so less water gets into the ice maker. However, over time, this will mean the valve will leak

...is an adjustment on the front of the ice maker for the amount of water that goes into the ice tray. It controls the number of seconds that the solenoid stays open and allows water to flow into

...goes into harvest the water continues to run and forms large blocks of ice over the cuber. I have replaced the float. I have also adjusted down the size of cubes to smallest. I don't know a lot about ...

...water is gettingold but after a minute or so it goes into the heating cycle The ice thickness probe is a plastic and metal piece hanging from the water distribution area at the top of the ice making ...

...adjust if needed. 3. LIKELY CAUSE, Purge valve does not open, water melts ice bridge, not enough ice to open curtain. PROBABLE SOLUTION, Check purge valve during harvest. 4. LIKELY CAUSE, incomplete ...

water trough to make sure it has a frost pattern all the way thru.(takes 5 min)If not it could be a leak it the sealed system. Remember when you adjust the setting on the board this will take 5 cycles

...water freezes but it never dumps the ice. this freezes and the ice keeps building-up but never releases the ice into the bin. I have cleaned the unit. It is level. You might try adjusting the ?ice ...