max with the speakers disconnected will not play a factor because there is no power being drawn so the amp is not being used. Those speakers are rated 90db and really pound but also draw a ton of amps
...set +2, and my Sherwood RX4105 receiver was able to play loud music on my loud speakers for 4 hours without the receiver shutting down. I cranked the volume to 52, then receiver shutdown. I tried to ...
set the vol control to 3/4 then adjust the vol to relatively loud and exit out of settings. this will be your max volume setting. Now, on to your problem.Unplug the receiver. There is an internal fuse
Question about Onkyo Audio Players & Recorders
...max. if it stays on, the receiver is ok and you then need to rehook your devices one by one starting with the speakers until you determine the one causing the receiver to shut off. however, if the ...
Question about Denon Audio Players & Recorders
...set its volume to Max and run through your receiver's speaker level setup. Write off the Tape Out as an input if you use it to extract the Front L&R channels. DO NOT monitor it or you'll chop the ...
...set its volume to Max and run through your receiver's speaker level setup. Any modern AV Receiver with the pre-requisite analog outputs should work. Since you have to buy a power amp for your 901 ...
...max volume. It doesn't seem to turn on when the receiver reaches a given temperature. Any suggestions? I know this post is pretty old, but I just came across it. I have a GTP-750 that I have fixed. ...
322 questions posted
Usually answered in minutes!
269 Questions
161 Questions
135 Questions
85 Questions
76 Questions