Question about Fedders Heating & Cooling
...motor by bending evaporator or condenser back far enough to allow it. if you have clamp on blower wheel have to bend evaporator out if set screw go through notch on vanes of blower wheel to
Question about Haier Heating & Cooling
...blower wheel and evaporator motor due to the old blower wheel broke. Now the evaporator motor won't turn on and I can't remember the connection points. Sure could use some help. there is a start/run ...
...blower wheel is turning but forced air ducts have blockage at inlet, which will require letting ceiling assembly down to inspect, or removing cover on roof and screws at front evaporator and opening ...
...heating. Look at the fins on your blower wheel ("squirrel cage") - if they are dirty then so are the fins in the evaporator coil. Access is a pain, sorry. Disassemble and clean from the
Question about Intertherm Heating & Cooling
...are typically wired for high and their is a schematic for wiring in side the unit. I would make sure your unit is clean evaporator condenser and blower wheel a dirty wheel will reduce cfm.Good Luck ...
clean? Is the evaporator froze up? Is the blower wheel clean? Is the return air open? All of these can cause low to almost zero air flow..... Good luck in finding which one is causing the problem.....
blower wheel, loosen the 3 screws which hold the evaporator coil to the housing. The coil can now be moved slightly forward which will allow the old blower wheel to be removed and the new one inserted
Question about Fujitsu Heating & Cooling
...evaporator fan from a Fujitsu 12C1 Unscrew pront panel and remove it. Unscrew PCB seating screws and remove it. Unplug motor jack, other jacks. Now unscrew motor seating screws, remove motor with ...
...blower wheel has failed (evaporator coil) OR the lower blower wheel has disintegrated (condenser coil in cooling mode) - which is very common on this Soleus Air model. The blower motors are very good ...
Question about Mastercool Heating & Cooling
...blower comes on... Belts have tightened and new pulley installed? Help Are you sure the blower wheel is not loose on the shaft. There is a set screw to tighten it to the shaft. How are the
107 questions posted
Usually answered in minutes!
347 Questions
334 Questions
307 Questions
96 Questions
65 Questions