...need to replace it. screws holding shaft to drum usually impossible to undo so drill them out using a 8mm bullet bit. fit new shaft, put some bearing grease on the bearing seal and re-assemble the ...
Question about Frigidaire Washing Machines
drum bearing shaft. When you rotate the drum, look for movement of the drum up or down while turning. If the drum moves suddenly, suspect the drum bearing. If it slowly moves up or down during turning
...drum to drop. seems like the spider shaft is stuck in the inner bearing from the seal allowing water in. I have the outer drum supported and used a block of wood and a hammer on the shaft, but it ...
...shaft turns freely yet drum & pulley are seized . Can't find anything stuck in drum to stop it moving could be bearings or a brake for the drum energized Call in a technician and get a repair ...
Question about Washing Machines
...drum shaft.4) Once free, there are 2 X 10 mm bolts that lock in 2 grub screws on the shaft. Loosen these an remove the grub screws and remove this coupling off the drum shaft.The drum is now free to ...
...drum does not, the drive shaft has broken loose from the three arms which attach it to the drum. (the part is called the "spider") To repair, remove bolt on end of shaft at center of motor. You may ...
...drum shaft. Unfortunately I am unable to get the drum shaft to slide out of the tub bearings. I have hammered on the shaft as much and as hard as I think I should with out doing damage. I am at the ...
...drum shaft due to rust and a new shaft will be needed if drum and shaft are out put wd40 on breaings and let soak then try to knock them out if the breaing breaks in the drum then a new drum will be ...
...if you can move the drum up and down, any slop would indicate shaft and/ or bearings 2) Turn the drum around and see if is running centrally. An off centred drum indicates you need new drum and ...
Question about Washing Machines
...drum in place and can take a bit of persuasion with a block of wood on the end of the shaft and a good hammer to get it to release. Make sure you use a block of wood to protect the end of the shaft ...
74 questions posted
Usually answered in minutes!
133 Questions
27 Questions
14 Questions
8 Questions
8 Questions