Question about Fisher and Paykel Washing Machines
...hot water, detergents, vinegar and bicarb of soda.These were done individually over quite a period of time but the smell still returns. So far it doesn't appear to have had any bearing on the clothes ...
Question about Washing Machines
tub until u go change it over to where it starts to wash the clothes and then when it gets to rinse it jus stays on rinse until u go change it to spin yourself!?! What's wrong with the washer!?! If it
Question about Speed Queen Washing Machines
...if you use it often it will start to build up. I mix mine with hot water before adding to a load of laundry and I avoid using the dispenser if I can, simply adding it to the load after the tub
...hot tub and it started OK but then stopped with the code 5n1. Is there a manual available to download? I'm assuming this is a Cal Spa? I'm going to reply to this but I'm willing to bet this issue ...
tub. I have found on many occasions that the pump has debris in it preventing a full drain. If you drop the bottom panel you will see the pump on the right side bottom. Get a pan, remove the hoses and
...tub but can't figure out how to get the top or front of the washer apart. I don't want to break any clips. it's a maytag PAV2300 Washer Basics: Filling with water: The water fill valve - The ...
hot and cold water hoses from the household plumbing. If either hose is leaking, tighten it or replace it, as appropriate. Main tub seal - The main tub seal is located between the transmission and the
...Hot water faucet is wide open and the cold faucet is open slightly. These are the same settings that my wife has been using for a number of years and never had a problem! But today upon pulling the ...
...tub and in the front seals. Eventually a mildew type scum develops and causes the washer to stink and also impart the odor to clothes. Even though front loaders do use less water and energy, all of ...
...tub. When you add water it increases the pressure in the tube and signals the shutoff. Sometimes the connections on this tube go bad.. or the tube itself gets a hole. Easy way to tell. Start the unit ...
68 questions posted
Usually answered in minutes!
123 Questions
40 Questions
24 Questions
26 Questions