Crown CE1000 2-Channel Amplifier "not turn" Questions

...not turn on monster mpa 5150 ss; when turning the power on the each channel indivisually turns on; but when it gets to the 4th channel the lights turn on and then it turns off; Repeats itself to turn ...

...not a volume control, as in variable resistor. It is called a Rotary Encoder. It is basically two switches that are pushed when you turn the control to the left or right. This creates pulses(actually ...

...not sound and after 5min turn off itself....after 10 min turn on again and get hot and not sound....??? You have a dead capacitor in the amp. Unless you are very apt at electronics, the amp will need ...

...where needed an amp should take up to 3/4 load but when not enough air to it to cool it off it will shut down try this turn gain all the way down and slowly work up too desired amp volume ...

...properly connected and still does not turn on, then try to supply 12V directly from the battery. If it turns on then your head unit has problem, If it does not turn on then your Amplifier has

...If so its internal...if not turn off again and attach one speaker at a time, turning the stereo off to add each speaker. until error. You could have a shorted speaker or wire or too many

...turn off and on again to avoid further damage. This task might not be a DIY since there are a number of measurements to do before narrow it down to a particular defective part. I would suggest to ...

turn-on? If not, check your speaker wires and/or speakers for issues. With all speakers (and wires) disconnected, the relay should still latch after turn-on. If not then you have an internal problem..

...turn the unit on the standby light stays on even though the unit turns on. I am not getting any sound from the unit. How do you get to know that the unit turns on .After power up what are sequences ...