Question about Onkyo Audio Players & Recorders
...connect the + speaker wire to the screw with the red marking around it. Connect your other speakers the same way, one speaker per pair of screws. You could blow the outputs of your unit if it has no ...
Question about Technics Audio Players & Recorders
...connect the speaker leads to the back of this amp, I've not seen terminals like them before. Cheers. Being a 500W amplifier, you need to connect speakers with 300W each. The correct method to ...
...The previous home stereo and amp came with 2 speakers, each having 4 wires for 4 speaker output connections on the amp for each speaker. My new amp has 2 speaker output connections for each ...
Question about Crown Audio Players & Recorders
connect load across it it will go into circuit protection to limit/stop excessive output current. make sure the speaker terminals are connected to +/- output terminals. in bridge mode use only channel
...Connect together the wires going to red on one speaker and black on the other. This now leaves you with two wires going to the other red and black terminals on the speakers, but the ends in your hand ...
...speaker. When I connect each of the two speakers individually,I have sound from each individual speaker,but when both are connected up just one speaker works. Through headphones,it sounds like both ...
...see what pair of speaker wires go to left the channel of the amplifier. One of each speaker must be connected to each amplifier´s channel, no matter of colors of the wires. Two wires for each ...
Question about Sony Audio Players & Recorders
connect a speaker of lower Ohms to an amp of higher Ohms than it. Must amps and speakers will fall between 4 to 16 Ohms. If your amp says 4 ohms you can connect just about speaker to it. But if says 8
Question about Technics Audio Players & Recorders
...poles 1+ and 1-, and speaker(2) with poles 2+ and 2-. We have amp output with poles amp+ and amp-. Connect speakers 1- with 2+ together,then connect amp+ to 1+ and amp- to 2-. Good luck! Thanks. ...
Question about Nady Systems Audio Players & Recorders
connect speaker wires without speakers attatched at the other side and test again. (make sure wires are separated and not touching metal!) if it stays on still, check speakers one by one, when it goes
69 questions posted
Usually answered in minutes!
68 Questions
33 Questions
21 Questions
21 Questions