...thermostat 9600 Robertshaw and I have to use the trip switch to start my furnace. Then it reaches the temperature and sometimes it will kick in by itself but majority of the time I have to trip it. I ...
AIR AND FUNACE RUN AT SAME TIME AIR AND FAN MODES WORK FINE BUT ON FURNACE MODE AIR AND FURNACE BOTH RUN. Change thermostat.
...furnace. Thermostat downstairs works fine but upstairs one cycles fan on and off 2-3 times during heating cycle. Have reset thermostat but no change. Have you checked to make sure that all of the ...
Question about Dometic Heating & Cooling
...Thermostat and a Tech guy checked the board in the furnace and it was OK. He also switched the board from the rear air with the front and nothing changed. Rear air and heat pump works fine. Have ...
...furnace wire (connection on thermostat) red (Rh) blue(Y) white (W) green (G) Any ideas for me? On a furnace the fan is controlled by a computer and a sensor ot a oldstyle fan thermostat. Basically it ...
Question about Heating & Cooling
...furnace. I think it's a wiring issue at the thermostat due to the very vague schematic in the owners manual when I wired it up. Any ideas? If the furnace fires but the fan does not come on after ...
Question about Dometic Heating & Cooling
...FURNACE IF GAS POWER BUT ELECTRICAL FAN DOES NOT REQUIRE A LOT OF ELECTRICITY. CHECK ELECTRICAL FIRST. WHY DID YOU REPLACE THE THERMOSTAT?? ARE YOU SURE OF YOUR THERMOSTAT WIRING? WAS IT AN IDENTICAL ...
...thermostat but still the same fan will not run in auto. have pulled wires off fan limit switch and it seems to be working with ohm meter. if I jump power to relay it works fine. where does power come ...
furnace switch when selected does nothing..cant even hear the relay board clicking.. but the fan works fine..High and low. I have checked the fuse in the relay box and circuit breakers on panel and on
Question about Dometic Heating & Cooling
...needs to be reset every day or two. Shut thermostat off for a few seconds them back on, furnace will work fine, then quits after a day or two. something is locking out furnace should get a
1 questions posted
Usually answered in minutes!
