Question about Maytag Kitchen Ranges
...for a bad sensor or charred sensor connector- if all tests OK, replace the control board... Maytag Range Stove Oven Oven Control Board WP5701M426 60 Maytag Range Stove Oven Temperature Sensor ...
Question about Maytag Kitchen Ranges
...thermostat failures can also make a control "think" it is in a clean cycle. Maytag Range Stove Oven Door Lock Motor and Switch Assembly WP74008702 Maytag Range Stove Oven High Limit Thermostat ...
...Maytag, said might be control board. Anything else to test before spending $$$ on control board which I think is the clock for $250+? make this test and fix it. God bless you F1:-1 Runaway Cook Upper ...
...control panel I have a Maytag MGR5770ADB. The clock and oven/broiler control panel does not come on. It's as if the oven is unplugged. Therefore, I can't use the oven. Sometimes, if I give it a good ...
Maytag Gemini electric double oven: Oven Control pad is not responding to touch - cannot use any oven; display looks fine - no error messages; cooktop is working fine. Any suggestions or repair manual
...Maytag range, what does F3 mean? When I try to preheat the oven, F-3 appears, it beeps, and then shuts off. F3 or F4 Shorted or open oven temperature sensor (RTD) Check sensor harness and harness ...
...Maytag range indicates a problem with the electronic control board for the oven or with the oven temperature sensor probe. A technician will need to diagnose and repair this type of failure. The ...
...Maytag model MER5775QAW free standing range. When you press "bake" and then set the temp. and press "bake" again the numbers instantly climb to the set temp and the buzzer beeps showing oven at temp. ...
Maytag Gemini model # 6772. Came home to the upper oven at full heat with the control panel beeping. Extremely dangerous situation where the oven would not shut off at the control panel. I had to shut
Question about Maytag Kitchen Ranges
Maytag 850 series double oven stove. Is there some code to enter to clear the oven so that the door will unlock? I was advised to disconnect power for at least 60 seconds to clear the control board. I
107 questions posted
Usually answered in minutes!
50 Questions
16 Questions