Question about Marantz Audio Players & Recorders
preamp with no subwoofer output connected to a 3 way B&K power amp. The power amp as a right, left and center inputs along with right, left and center outputs for speaker wire. Currently hooked up are
preamp output i have a kenwood vr 7070 THX select reciever with a 7.1 preamp output. my question is if i hook up the m-282 amp to that output for the 6th and 7th surround speakers will i have to get a
Question about Adcom Audio Players & Recorders
output in Right channel on my Adcom preamp GTP-450 I have tried evrthing but I'm not getting output out of my right channel from this preamp. This happened suddenling after years of use Hi... Have you
Question about Bose Audio Players & Recorders
output is without the VCA. Most amps default to full ON and the preamp attentuates the signal with a volume control. Try it with a signal that fades in slowly so you can intervene if it gets too loud.
Question about Audio Players & Recorders
...preamp outputs i want to hook up yamaha mx460 for music only can i hook up through the tape monitor output yes, you can have output signal at tape monitor output terminal and can be hooked to any
Question about Marantz Audio Players & Recorders
should i hook up to the tape side of the preamp No. You should use the line(or preamp output) to the Carver input. The only way you could use the tape output is if the Carver has input volume controls
Question about Bogen Communication Audio Players & Recorders
preamp signal at phono plug but no power side output and cooling fan does not function. Fuse is good. Robert it sounds like you have a power supply problem try and check for a blown diode inside close
Question about Audio Players & Recorders
...Volume, bass, treble... and then send a sufficient signal to the amp to drive the amp to power your speakers. As long as the preamp output is enough for your Amps input any will work as most will
Question about Denon Audio Players & Recorders
...ok when you test them by regular meter. Check 1.2 kOm and 4.7ohm resistors at preamp pcb. Check diodes on output pcb (could be smd type, connected from base of output transistors to emitter i
...preamp, as it's volume control would not affect the Tape Output, so the output would be at maximum volume. If your scheme involves an amp that has it's own volume and other controls, it would
39 questions posted
Usually answered in minutes!
62 Questions
68 Questions
21 Questions
21 Questions