Crown XLS 602 2-Channel Amplifier "blown channels repair" Questions

...blown. These are not the easiest units to repair. Given that this is a commercial amp, I would recommend that this unit be brought to an authorized Crown service center for repair. Expect parts cost ...

...channels and speaker and wire are working which component is most likely blown and is there any schematic for this particular amp available for a free download thank you NAD 355BEE SM Service Manual ...

garbled. You may have a blown channel. Check for fuses inside but I don't think that it will help. Repair if the channel is dead is not worth doing as the amps value is probably lower than repair cost

Myryad MA500 blown channel One of my channels is out on the Myryad MA500. What's my next step, as Myryad tells me there are no repair places in the US? Try the repair directory on this site

...blown Unfortunately there is little we can do directly. The output transistors are likely to be shorted on the bad channel. This is not a DIY repair for most people. Expect a repair bill in the $80 ...

blown again. Disconnect the dead channels speaker connection at the Amplifier, if the short goes away then you have a shorted speaker voice coil or wiring to speaker, if still blows the fuses you have

...definitely blown outputs to have caused it. Most electronic places should be fine to test advise and repair. Would suggest outputs and drivers, but unfortunately not always that simple. Best of ...

...blown channel. If you are experienced with electronics repair, use the right channel to assist in diagnosing the left. Both channels should be efectively identical. In most cases, the defective parts ...

...of blown output transistors since the relay does not go into protect and sound is audible but distortyed in one channel. Safe ! Jango have you tried switching source channels? right to left v.v. ...

Blown fuse no sound in one channel After 9 days new my Primare I21 amplifier blew a channel (no sound from one speaker). The repairer said there was a blown fuse caused by shorting of the speaker ...