2004 Toyota Sienna "air bleed valve coolant" Questions

Question about Cars & Trucks

2003 lincoln aviator water boiling and car overheating

...air bleed valve on it and you need to bleed the air out manually. To bleed it you will have to crank engine and get it warm. Touch top radiator hose to see if its warm. If not then the thermostat has ...

Question about Toyota Sienna

1 Answer

My 01 Cavalier is overheating. I changed the thermostat and do not see any apparent leaks. The heater was blowing hot air before I changed the thermostat and now it's only blowing cool air. Any

...air bleed valve. The coolant air bleed valve is located on the top of the thermostat bypass pipe/heater pipe assembly. Close the valve once a continuous stream of coolant is expelled from the ...

Question about Cars & Trucks

1 Answer

Hvae 2 bleed valves on my buick century how to bleed air out the systemi have to bleed valve on my buick century how to bleed air out of system

...bleed air out the systemi have to bleed valve on my buick century how to bleed air out of system if its coolant bleeder just crack them open one at a time and when only coolant comes out close it and ...

Question about Toyota Sienna

1 Answer

Air in coolant system

Air in coolant system Loosen the bleed valve Run the engine until it's hot and when the coolant runs in a steady stream thru the bleed valve(no more bubbles)tighten the bleed valve

Question about Cars & Trucks

2 Answers

Just replace ed the radiator in my 2004 Sebring and now it keeps overheating but the coolant is still full

...air will have to be removed. DO this by running the vehicle at idle and opening any bleed valve that may be equipped until coolant comes out. If no bleed valve, run engine until thermostat opens ...

Question about Cars & Trucks

1 Answer

Y dose the john dear 6330 run hot all the time

...Air is entering cooling system, hindering coolant flow. Check coolant level. Fill to the "MAX" line on the coolant reservoir. Bleeding Cooling System: The bleed valve (see Operator's Manual for ...

Question about Toyota Sienna

1 Answer

Engine gets hoat some time, no heat from heater.

...bleed valve and allow the cooling system to purge the air out of the system you can tell when the air is out of the system when a steady stream of coolant starts to flow out of the bleed valve, if ...

Question about Toyota Sienna

2 Answers

99 Chrysler 300M. As there is no visible radiator

...COOLANT RUN OUT BLEED VALVE ON THERMOSTAT.GENTLY SQUEEZE THE UPPER RADIATOR HOSE UNTIL ALL THE AIR IS REMOVED FROM THE SYSTEM.CLOSE BLEED VALVE MAKE SURE IN OVERFLOW AT COLD MARK.DONT OVERFILL

Question about Toyota Sienna

2 Answers

Even if my coolant is full, the car isn't overheating and the light stays on could it be that the coolant isn't getting to where it needs to go?

...bleed valves to purge air from a system that has been opened for repair or replacements. Check an old Chilton manual if you can find one for the make and model of the vehicle. It will give you the ...

Question about Toyota Cars & Trucks

1 Answer

Do I have to release a valve when adding antifreeze to radiator on 2006 toyota sequoia?

...air bleed valve, high on the block or head, often right on the thermostat housing. Such a valve if equipped, will be at the highest point of the coolant passages in the engine, used to bleed air from ...