1996 Toyota RAV4 "bearing noise pinion" Questions

...pinion bad noise on bearings in diff no leaks though but want to replace all bearings and seals do i need to replace the collapseble sleeves as well and where can i get a drawing off the diff layout ...

...pinion gear bur under coaste the load shifts to the bearing next the the pinion drive nut I suspect that bearing is failing allowing the pinion to comes out of correct mesh position causing the

...bearing is gone I suppose because it is making a screetching noise. There is no play though between the propshaft and the pinion. all diffs are constructed the same check if there is any oil in the ...

...noise is occurring on acceleration it will be the rear pinion bearing if it is on deceleration it will be the front pinion bearing if it comes and goes s you drive normally it is the incorrect mesh ...

noise replaced rear pinion bearing, fresh lub, replaced race and sleave. noise is still there. while drive shaft is not connected the pinion shaft it is locking up in the differential. only in forward

...bearing type noise when decelerating would usually mean the small bearing on the differential pinion shaft and a noise when accelerating would be the large bearing on the same pinion shaft in the ...

...bearing If the noise is in overdrive ,(coasting down hill or to ma stop , it will be pinion bearings (diff). If it is in 1st gear it will be input shaft bearing in gear box . If it is in overdrive it ...

...bearing noise will change pitch from acceleration to deceleration. Side bearing and axle bearing noise change pitch with road speed. Dana 35 series( oval cover) differentials tend to eat pinion ...

noise is usually caused by a bearing that is worn or has pitting in the bearing race (half of bearing without rollers). A whining noise would be caused by worn ring and pinion gears. the roaring could

...causes a "chattering" sound. When a pinion bearing goes bad in these Jeeps that is the noise they will make, even at lower speeds. Hope this helps.. this is the front pinon bearing making this ...