Question about Toyota RAV4
hi need to replace bearings on my rav4 96 model diff do i need to replace the collapseble spacers as well and what is the clearance settings on crown wheel and pinion bad noise on bearings in diff no ...
Question about Cars & Trucks
...starter for tightness and any corossion . The starter can be getting tight from wear or the engine bearings can get tight causing over current draw and heat . A locked up or seizing air conditioning ...
...normal condition of the starter motor. Low free speed and high current draw indicates worn bearings, a bent armature shaft, a shorted armature or grounded armature fields. Failure to operate ...
I need a drawing of how the steering box goes together. The bearings are out and there is one spring that I can't figure out where it goes. Any tech drawings would be greatly appreciated. try to ask a
...and power off ] for debris or damage--listen for bearing noise or labor running --test amp draw if high possible bearing dry or damaged ---most pumps also are thermal protected will shut down when ...
Question about Cars & Trucks
1971 xw 302 V8 with bendo stromberg carb model WW. 2 ball bearings , 1 for the accelerator pump, the other goes where ?? - thanks wayne both ball bearings are the inlet and outlet valves for the ...
Question about Lincoln Cars & Trucks
2000 Lincoln Navigator rear bearing assembly I need a drawing or some advice Rear drivers sides is making loud after I changed the brakes, how can I tell if it's the bearings jack up that side and ...
bearing should the pilot take? Answer should be given in degrees and minutes. Draw the airport. (X marks the spot) Draw the distances from the airport (to scale) to indicate the position of the Plane.
0.006 in. WARNING THIS IS THE 2.8L ENGINE WHEN TORQUEING CAM SHAFT BEARING CAPS YOU HAVE TO TIGHTEN THE BOLTS 2 TURNS AT A TIME IN A DIAGONAL PATTERN TO DRAW THE CAMSHAFT DOWN AGAINST THE VALVE SPRING
Question about Cars & Trucks
...so hot u can't touch it We are pumping normal water at 25 deg c If it is running at max amps, the bearings and/or brushes are worn out. Yes it will get very hot. If it is a motor separate from the ...
529 questions posted
Usually answered in minutes!
521 Questions
461 Questions
363 Questions
313 Questions
345 Questions