1993 Toyota Previa "turn blinking change oil light" Questions

...turn off oil change light. hi friend, 1.With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B). 2.Turn the car off (ignition key to the OFF position). ...

...change has been done.*** Take the ignition key and a "BIC" pen with you. Sit in the driver's seat and put the key in the ignition, Look at the gauge cluster and find a small black rubber plug (It is ...

...gas pedal three times. This will reset the system and turn off the blinking light. Then when you drive another 3000 miles, that light will once again tell you it is time to have your oil changed.

...blinking and the chimes will stop, hope this helps To reset the "Change Oil LIght" the procedure is as follows: Turn the ignition to the "ON" position. Press the "RESET" button inside the driver's ...

...Change Oil light will not go off, what is the code? Turn the key to the on position and press the gas peddle down to the floor 3 times within 5 seconds,then wait 10 seconds. Turn the key off then ...

...blinking in the meter continuously as I also change the Engine oil in time U have 2 take it back 2 whomever changed the oil so the warning light can b reset! You still have to rest the computer after ...

...light . Turn ignition key to the on position (with engine off). Depress accelerator pedal 3 times. Oil change light should blink and you should here a beep, light will go out. Turn ignition key

...blinking. Any clue? the car is telling you that the oil needs to be changed/ the milage has reached the limit for needing to be changed. even if you have changed the oil it will still warn you after ...

...change oil light in 2002 gmc envoy On a 2002 Envoy you turn the key to run but don't start it. Then push and release the gas pedal 3 times within 5 seconds. The change engine oil light should blink ...

...CHANGE OIL LIGHT ONCE THE OIL HAS BEEN CHANGED AND THE SEVICE ENGINE SOON LIGHT ON A 2002 GMC YUKON DENALI XL? look in the manual......turn the ignition to the on position not starting it of course ...