...converter (transmission) issue. Run a good fuel system cleaner through it. If they replaced ECM you shouldn't pull that code again, it's more like a simple dirty fuel filter or condensation in
...replace the MAF sensor its the unit on toyota vehicles that calulates how much Air intake is going into the throttle body and then sends a signal to the ECU of your car which adjusts your Fuel ...
...fuel filter on 1 96 olds lsss replacing a fuel filter on a 96 olds lss 1996 Oldsmobile 88 LSS 3.8L SFI OHV 6cyl the Fuel Filter is located under vehicle, passenger side, below seating area, front of ...
...fuel filter, where is the location of the fuel filter? Along the frame rail under the car you should see the fuel lines on the driver side. Along the line around the front driver door area there ...
Question about Cars & Trucks
...on 96 olds 88, but still no fuel pressure. Have ruled out a spark issue; is fuel. do not believe fuel filter was replaced, or relay. Now what? Test the electrical circuit . GM Fuel Pump Relay ...
...fuel filter, spark plugs. Please help! I have a 15 month old baby and cannot be without a vehicle. Bring it to someone that knows what they are doing. Does it have spark?, Fuel?, Compression?, Timimg ...
Question about Toyota Corolla
...fuel filter put back in the line. Could the injectors now be plugging due to junk in the line? How long since a tune-up? Any applicable trouble codes? If you have the spider fuel system, that system ...
Question about Cars & Trucks
...will turn over but won'tstart. ... i a 93 k5 blazer 5.7tbi in cold weather it will not start, if i hook jumper ... was told it just needed a Fuel pump, I replaced the Fuel pump, and the Filter,
Question about Toyota Corolla
...Fuel tank had to be lowered and pump assembly is right on top. Don't forget to replace the electrical connector...it should be included with the new assembly. I had the fuel injectors cleaned at the ...
...fuel filter and replace it with a new one. Connect the fuel hoses and tighten the hose clamps. Position the filter on the frame rail and tighten the retaining screw to 75 inch lbs. (8 Nm). 1994?96 ...
1,826 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
819 Questions
767 Questions
792 Questions