...REMOVE VALVE COVERS AND CAMSHAFTS TO GET TO LIFTERS.YOU NEED A HAYNES REPAIR MANUAL FOR THE TORQUE SEQUENCE FOR THE INTAKE MANIFOLD.ALSO TO ADJUST VALVE CLEARANCE.THIS IS A HARD JOB WITH OUT A REPAIR ...
...of the cams jumped from valve spring pressure and now you'll have to remove the front cover, re-time the cams to the correct position. ...
...THE PIVOT BOLT. DISCONNECT THE VACUUM HOSES FROM THE AIR CONTROL VALVE, IF EQUIPPED, WITH DRAW THE BELT. ON SOME VECHICLES IT MAY BE NECESSARY TO REMOVE THE PULLEY IN ORDER TO REMOVE THE DRIVE
...Remove the valve cover. One of the cams has a spring loaded gear on it that has a bolt hole to install a bolt on it so the second half of the gear does not loose pressure. I believe that it is the ...
remove and replace gasket on valve cover on a 1993 jeep. All bolts are off and cables out of the way but it is not moving. We have used a mallet but still not moving. Take a putty knife or similar and
...TO RATE THIS POST!! PCV valve is on the valve cover, will have to remove engine cover in van, fuel filter in under the van, on drivers side, around the front door area, on the frame rail inner
make sure you have the right one for the truck. Now just pull the old one off of the valve cover and remove it from the hose and insert the new one than reinsert it on the valve cover and you are done
how to replace valve cover gasket Remove the valve cover bolts then and the cover, scrape both surfaces clean then reinstall the new one. It.s that simple!
...car.they come with them in the set.or you can remove the valve covers then the semi cicular plugs you can try to put a coating of silcone sealer on the plugs and the valve cover gasket to reseal
a valve body failure.Not hard to replace,Just remove battery and battery box,then will see valve body cover from top.Remove cover ,then valve body. Just be very careful not to drop anything into trans
1,718 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions