...belt can I drive it to the shop without damaging the valves? A 6 cylinder is an interference fit engine . Chances are you bent some valves IF the belt slipped. Mounts usually don't make a vehicle ...
...belt replaced, it broke while driving it.1992 Toyota Camry with 24 valve v6. Is this a valve hit piston engine? yes i am sure it is /u can call NAPA and ask for timming belt and ask them when they ...
...cam belt also drives the water pump and for this reason I recommend you replace the cam belt at 120,000 miles when you replace the cam belt the second time. Neither engine is an interference
...replace. Thanks, Syed Cylinders 2 - 4 - 6 are facing the radiator. Cylinder 2 is closest to the drive belts. Cylinders 1 - 3 - 5 are facing the firewall, cylinder one closest to the drive belts. Hope ...
...belt, can I drive it to the shop without damaging the valves? Hello, and welcome to FixYa. Yes, you can drive the car to the shop without fear of any internal engine damage. Your engine is not an ...
...drive or reverse. What is the likely sources and solution to check if belt spray water on the belt and if the squeak goes then adjust /replace the belt. When the belt dries out the noise will be back ...
hoses.Then remove the belt covers.The lower cover will require you to remove the belt drive.once removed you can remove the old belt and reinstall it. try this out.. thank u.. kindly rate my response.
Question about Toyota Camry
I recently replaced the tranny on my 92 Camry LE v6 which died at 203K original miles. After installation and while test driving I noticed that the reading had jumped to 212K miles. What caused this a
...make sure the timing marks on the cams and crank are set properly. No but also replace t belt tension pulley seals waterpump and drive,belts it time 60-90 thousand miles they break at aboit 90000 ...
1,411 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions